Skip to content
Magna Studio
Menu

Richmond upon Thames · Loft conversion · Checked 15 Sept 2026

Do I need planning permission for a loft conversion in Richmond upon Thames?

Short answer

Often not. A rear dormer adding no more than 40 m³ of roof volume on a terraced house, or 50 m³ on a semi-detached or detached house, set back from the eaves and below the ridge, is normally permitted development; front dormers, larger volumes and any loft to a flat need planning permission. In a conservation area roof extensions always need planning permission. Richmond upon Thames has conservation areas and Article 4 directions that remove some permitted development rights, so we check the address on Richmond upon Thames's constraints map before advising a route.

Get an instant estimateIndicative fee in two minutes. Written fixed-fee quote within 24 hours.

The permitted development rules for loft conversions

A loft conversion with a rear dormer is permitted development on a house if the added roof volume is no more than 40 m³ on a terraced house or 50 m³ on a semi-detached or detached house, the dormer sits at least 200 mm back from the eaves and no higher than the ridge, there is no dormer on the roof slope facing the road, materials are similar in appearance, and side windows are obscure-glazed.

Flats and maisonettes have no permitted development rights, so a loft to a top-floor flat always needs planning permission. Full-width box dormers that reach the ridge, and hip-to-gable conversions on semis whose volume exceeds 50 m³, also fall outside the allowance.

What changes in Richmond upon Thames

Roof extensions are not permitted development in a conservation area, so a dormer or hip-to-gable there needs a householder planning application designed to the area's appraisal.

The local constraints that most often decide the route in Richmond upon Thames are listed below, taken from our Richmond upon Thames area page. Each one is a reason to confirm the address on Richmond upon Thames's constraints map before relying on permitted development.

  • Conservation areas. Richmond has more than 70 conservation areas, covering a large share of the borough's housing. Roof extensions, cladding and side extensions in these areas need planning permission rather than permitted development, and the council publishes character appraisals that officers use to judge design. Check the constraints map for your address before assuming PD applies. Source
  • Article 4 directions. Many Richmond conservation areas carry Article 4 directions removing permitted development for front elevations, windows, porches, boundary walls and hardstandings. The exact rights removed differ from area to area, so we check the schedule for your street before recommending a route. Source
  • Thames flood zones. Low-lying land at Barnes, Mortlake, Kew, Twickenham riverside, Teddington and Hampton falls within Flood Zones 2 and 3. Basements and new ground-floor habitable rooms may need a flood risk assessment, and the Thames Policy Area adds design expectations for riverside sites. Source
  • Metropolitan Open Land and Royal Parks. Richmond Park, Bushy Park, Kew Gardens (a World Heritage Site) and Ham Lands are Metropolitan Open Land or protected landscapes. Houses backing onto them are judged on their effect on openness and setting, and outbuildings near the boundary attract extra scrutiny.
  • Listed buildings. The borough has a high number of listed buildings, particularly around Richmond Green, Richmond Hill, Petersham, Twickenham riverside and Hampton. Almost any external or internal alteration to a listed house needs listed building consent in addition to planning permission.

What Richmond upon Thames planning officers look for

Richmond is one of the more design-led London planning authorities and its officers apply the House Extensions SPD closely. Rear extensions deeper than neighbouring precedent, roof extensions that are not clearly subordinate, and front dormers are common refusal reasons. Side extensions on suburban semis are expected to be set back and lower than the main roof so the gap between houses reads. In conservation areas expect detailed comments on windows, brick and rainwater goods. Pre-application advice is available for a fee and, in our experience, is worth it for anything in a conservation area or on the river.

Fees and timelines

The council fee for a householder application is £528 and for a Lawful Development Certificate £264 (England, from 1 April 2025; verify before applying). Both are decided within 8 weeks of validation.

Our own fee for the drawings and the application is fixed once quoted and depends on the project type, its size and the constraints above. Answer six questions in the quote tool and we email you an indicative figure within minutes, then a written fixed-fee quote within 24 hours.

02Questions

Loft conversions in Richmond upon Thames: common questions

How is the 40 m³ or 50 m³ measured?

It is the volume added beyond the original roof slope, including any earlier roof extensions, not the floor area of the new room. We calculate it on the drawings and include the calculation in the Lawful Development Certificate application.

Can I have a front dormer?

Not under permitted development: nothing may extend beyond the plane of the roof slope facing a highway. Front rooflights are fine. A front dormer needs planning permission and most councils refuse them unless the street already has them.

Do I need Building Regulations approval as well?

Yes, always. Permitted development and planning permission concern what you may build; Building Regulations govern how it is built, including the new floor structure, the stair, fire escape and insulation. We prepare that package after the planning route is confirmed.

How long does Richmond upon Thames take to decide?

The statutory period is 8 weeks from validation for both a householder application and a Lawful Development Certificate, and 42 days for a larger home extension prior approval. Busy periods can push decisions past the statutory date; we tell you where the council is running.

03Examples

Example projects that face these questions

Proposed loft floor plan for a hip-to-gable and rear dormer conversion to an Edwardian semi in TwickenhamExample project
Loft conversionTwickenham, Richmond

Loft Conversion in Twickenham, Richmond upon Thames

Hip-to-gable roof extension with a rear dormer to an Edwardian semi-detached house in a Twickenham conservation area, creating a master bedroom and bathroom in the roof.

Typical route: Householder planning application in an Article 4 conservation area

Next step

Planning a loft conversion in Richmond upon Thames?

Answer six questions and your indicative fee arrives on screen and by email. Written fixed-fee quote within 24 hours.